Discussion Locked

2 "C" Drives

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Due to a corruption of several Xp systems files the operating system would not start. I had two Hard drives in the machine at the time (the 2nd serving as a partial data backup). Windows would not allow me to repair the problem offering only to delete the partition and start again -- which I do not want to do. So, I installed Windows XP on the 2nd drive (overwriting the backup data) and now find that I have two C drives.

Disk 0 (C:) Healthy (System)
Disk 1 Health (Active)
Both show as primary drives.

Windows explorer does not show the 2nd drive (which contains all my original program files and data files).

Computer Mgmt: Storage etc will not let me change either drive letter; niether will the Diskpart command allow me to changeeither drive letter. Nor will it "clean" the original faulty drive. Any ideas as to how I get at the original drive and "clean" out the operating system info so I can access the data?
Thanks...

5 replies

by wim

This is what i should do, unplug your "good" (with all data) drive and install W2K(if you have it) on the drive. It's probably possible with XP also, but if you use W2K, it's easyer not to make unrecoverable mistakes. Than connect the "good" drive and boot up W2K, now you'll be able to give it a drive letter (if not done automaticly)

Put the W2K as master and your backup drive (with XP) as slave...
If your able to get the data, place it on your W2K disk, check it, format the XP drive fat32 and copy it back on this fat32 drive (fat32 = able to access with bootdisk)

Now that you have your files (backup), go ahead and install Xp on your system disk.

hope you'll recover your data

by ron larson

I would disconnect your 2nd drive. fdisk your first drive then reformat it and install XP then I would attach your 2nd drive as a slave and copy all your data to the first drive if you have the space then reformat the second drive and copy all the data back to it

This discussion is closed to new replies.