Discussion Locked

2 Networks on Same Machine

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Win 2000 Pro PC with 2 NIC cards and I am trying to connect to 2 separate networks. Both have static IP addresses. Network A has high speed internet available, Network B does not. Network A uses the IP address format 192.1.1.X, wile Network B uses 10.152.6.X, Subnet mask is same for both 255.255.255.0. Both have different Default Gateways and different DNS Servers.
I can't get both to work at the same time. One works when I disable the other and vice versa.
Is there any way to be able to connect to both networks simultaneously??
Thanks much.

4 replies

by sab_arturo

In XP, there is an option to 'bridge connections', not sure if this is possible in 2000 pro, but i imagine it is. Look around in the network windows, and try the windows help maybe...

by malkeetdxb

After going through ur question above what
i feel is the different subnet mask.
B'cuz IP address 10.x.x.x belongs to Class A
and subnet mask for this class is 255.0.0.0,
where as IP address 192.1.1.x belong to Class C,
and subnet mask for this should be 255.255.255.0,
try changing the subjnet mask it should work.

by mshavrov

It's not a Windows problem. Windows itself can handle different networks on different card simultaneously. But you should your IP routing tables. Most likely you have 2 "default gateways" on your computer. Do the following:

1. Check your routing table.

c:\> route print

2. If you have 2 lines like "0.0.0.0 0.0.0.0", you should remove it for "Network B" (no-Internet LAN).

c:\> route delete 0.0.0.0 mask 0.0.0.0 10.152.6.1

This will remove "NetworkB's" default gateway from your routing table. Althought you may need to add static routing to resources (servers, printers, etc. which are available through networkB but do not belong to it (i.e. you have router and your servers are on 10.152.5.x). In this case add routing to that networks through NetworkB's default gateway.

c:\> route add 10.152.5.x mask 255.255.255.0 10.152.6.1

This should solve your problem. If you have more details, contact me through e-mail.

Good luck,

Michael Shavrov
MCSE W2K, MCSE+I, CCNP, CCDP, Security+, ...

by deadly ernest

The problem here is the gateways.

In any network you have the subnet mask which tells your system which machines are part of the local subnet. You also have a gateway defined and the gateway is what you tell your system to do with any traffic that is not local. Thus if it is not local it is to be sent to this IP address.

You can have a system that talks to more than one network and it will see each network as being local to it. But it can NOT send non-local traffic to two gateways. only one.

Decide which of the gateways you wish to use and then remove the gateway information from the configuration of the other NIC. This will allow you to talk to both networks and to talk to anything else over the selected gateway.

You can also have a similar problem if you have only one DNS server set up in each. It is best to set up the DNS servers in both NIC configurations that way your PC will check one then the other. Choose one as the primary and the other as the secondary and set up both the same way.

This discussion is closed to new replies.