Discussion Locked

20GB HDD on PII CPU

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to add 20GB Maxtor HDD into my PII 266MHZ whose motherboard is Intel AL440LX. Initially, the BIOS reads my new 20GB HDD but does not boot up. So I boot it (new HDD) in a new CPU and installed WIN2k Pro& other software. Then I fixed it up inmy old CPU(PII 266MHZ) and tried to boot it. The BIOS once again reads the 20GB HDD & tries to load the WIN2K. Suddenly it goes back to the first screen when booting up then load again the WIN2K then repeats the cycle over and over again. It fails to get into the login screen of Win2K.

I check the manual of the motherboard to see what it supports. It mentions the processor speed + the SDRAM. But nothing was mentioned on HDD capacity.

Is there any way I can use my 20GB in my PII266 CPU? I would appreciate your help in this regard.

Thanks a lot.

11 replies

by dmiles

The Bios does not support this haard drive capacity.
Check the Post screen for the Bios manufacturer and then go to their web site and download the flash update,download and flash your bios,also check with Microsoft knowledgebase and get the updated version of ATAPI .exe to supoort large hard drives for NT and updated to at least service pack 3.

by chris hirst

Did you when you swapped HDD use a different MB? If yes there is your problem you cannot make a setup of Win2k or NT start with different makes\models of MB,s. The HAL (Hardware Abstraction Layer) is different for each board, You can upgrade CPU,s Video, sound etc because these drivers are loaded later and can be replaced by the PlugnPlay subsystem.

by argusvj

i'm not a techie person. i learn to assemble PC as a hobby. so i thought your tip was really 'abstract'. i tried other suggestions and downloaded iflash to update MB but my MB (readme.txt says so) supports HDD >8GB.
anyway i started on a clean slate: partition and format anew then install my Win2K and alas! my computer boots up. in fact i'm not using this old PII 266mhz with a new 20GB maxtorHDD.
THANK YOU SO MUCH.

by estebandelatorre

Some bios motherboards may not read (support) larger HDs. That's your problem.
You can check it by booting into dos mode or with a w98 boot disk, then issue an Fdisk and try to see the current partition info. It will show a size near 8Gb!.
The mobo can format the unit, but it will allows you only 8GB not 20Gb of disk.
Download the last bios update for your mobo and upgrade it.

hope it helps!!!

by atlas12

Try using Maxtor's MaxBlast Plus Hardrive Utility. At this site: http://www.maxtor.com/Maxtorhome.htm This should alow you to use that 20 gig drive even though your cmos dosen't see the drive. Last week, I installed a 20 gig Western Digital drive using their hardrive utility (Just Like The Maxtor)in an older Gateway machine and it was a flawless install and it worked Great..
Hope this helps!

This discussion is closed to new replies.