Question Locked

2.5" HD in USB Enclosure

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently replaced my laptop's hard drive (Toshiba MK4025GAS 40GB 4200RPM)with a (Western Digital Scorpio WD1600BEVE 160GB 5400RPM) and I bought a USB enclosure so I could still use my old drive for storage space, to back up files, etc. When I have the Toshiba HD in the laptop and the WD HD in the enclosure things are fine, however when I switch them the WD HD boots and runs fine, but I can't get the Toshiba HD to work in the enclosure. My computer says it found a USB Mass Storage Device, but then says there was a problem during the hardware installation. When I look in the Device Manager it says there is a USB Mass Storage Device connected to one of the USB ports, but when I open the properties, it says This device cannot start. (Code 10). Once again, there is no problem when I switch the Hard Drives. Does anyone have any ideas to fix this?

13 replies

by gary56789

manually updating the driver for that drive (this is what code 10 means).

by aswat12389

Can you help me out a little more here? ie where to get the new driver, how to install, (is it just an executable file?)

by kevinbramgrant

1. What operating system are you running?
2. What brand Laptop from what i read i assume its a toshiba but i cant be sure?

3. What brand is the enclosure?
4. does your Laptop carry USB 2? - most laptop carry both.
6.i would tend to think it is a driver issue but then depending on the OS it should already have the driver in the HCL.

when i get a reply i will try and figure out the rest. I hope i am analying the Synerio correctly.

by aswat12389

1. Win XP sp2
2. It's actually a Compaq V2000
3. Link Depot model ENWB-25B-SS
4. I believe so.

by dhulapati

I have exactly the same problem. I am having a Toshiba HDD and a brand new USB-IDE cable.
It says USB MASS STORAGE DEVICE
and after a while "ERROR OCCURED IN INSTALLING THE HARDWARE"

by aswat12389

So If anyone had any thoughts on this that would be great!

by carfren

i have the same problem, i have that link-depot ENWB-25B-SS enclosure, and a toshiba MK4021GAS hard drive, when i use a hitachi hard drive it works like a charm, but when i plug the toshiba, it just says code 10, and i tried it on linux and gives an error too.

by alan williams

The USB enclosure was installed with a set of Parameters. When you change the drive in the enclosure, the parameters do not match.
Try deleting the device in the hardware manager, possibly under hidden devices, and re-installing it.

by riverseow

My problem is exactly as yours. Works when the old HD in the laptop and the new one in the encloser. Swapped, the old Toshiba one does not work in the enclosure. After almost half a year, I realized the old HD was protected in the BIOS by password. After I removed, it works now in the enclosure. See my similar post in the other post. (https://www.techrepublic.com.com/5208-10879-0.html?forumID=56&threadID=193017&messageID=3235698)
Hope it helps.

by 93961

The post is 27 months old and may be forgotten by the OP.

This discussion is closed to new replies.