Discussion Locked

3 1/2 floppy not accesable

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My os is win98 with an older AMD333 processor on a mother board i dont have any information about.On initial boot up it is seen and on system devices there is no conflict noted.The problem is i cant read or write to it and the machine will not boot from it on start up.
I have asked this question before and have been and have been advised to remove the IDE controllers and re boot.I am a novice at this and i dont want to remove something that should stay and create more problems.More specific advise on which IDE drivers and that sort of information would be greatly appreciated
I thank everyone for there help in this matter
Chris Wilcox

5 replies

by shanghai sam

Hi Chris,

Just to cover the basics, you are certian that;
1. the drive is good,

2. the cable is good, and connected properly (the section with the twist is between the floppy drive and the motherboard)(the polarity is correct on both ends) Ifthere is not a twist in the cable, by default, the drive is drive "B:".

3. BIOS settings are set for the correct floppy type at the correct drive location.
In advanced options, the switch should also be set to report floppy drives to windows.4. The drive cycles the light, and spins the motor when you boot the PC. (this is the drives self test, if the drive does not run the self test, or the light stays on, then you have a hardware problem)

The fact that you cannot boot from the drive suggests a hardware or BIOS setting problem.
The drivers are not involved until Windows is loaded.
Make sure that in BIOS settings that the floppy drive is listed in the boot sequence before the hard drive.

The reason it has been suggested to remove the floppy drive and controller from device manager, is that this is the simplest way to have windows self-repair any problems with the driver.

Looking at Device manager on my windows 98 system, the devices to remove are;
The floppy drive,
The floppy drive controller,
and if needed, the branch for the floppy drive.

Make sure that on the Performance tab,
under file system / floppy drive
That the box to search for new floppy drives is checked.
Click apply.

After you re-start windows, it should automatically find the floppy drive controller, and install the driver.
Then, it should find the floppy drive, and install it.

continued;

by thechas

Here is the continuation of my answer.
For some reason, it assigned me as user deleted, and would not allow me to add a comment.

For some motherboards, you may need to install the chipset drivers.
Since this is a super socket 7 motherboard, you likely have one of 3 manufactures chipsets on the board. (ALI, SiS, or VIA)
If you look at device manager, it should list what chipset you have.
Under Hard drive controller, there should be primary, secondary, and master. The master should identify the actual chip manufacture.
Likewise, if you expand the system devices branch, there should be several devices listed as "bridges" the description should also list the chipset manuafacture.

Alternately, you can run Belarc Advisor (www.belarc.com) and it will provide 2 pages of details about your system.
Look under controllers and bus adapters to find out what chipset you have.

Then, go to the chipset manuafactures web site, (links at www.driverguide.com) and download the W98 versionof the drivers.

Run the file, (some are zip files) and install the driver update.

Unless there is some burried driver issue, that should take care of the problem.

The next step is to go through the registry and system files.

Chas

This discussion is closed to new replies.