Discussion Locked

3com 3C509-TP NIC Card - Config Help

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have installed a 3C509TP in two computers (one running Win95 (No PnP) the other Win98 (PnP capable). Both PCs recognize the cards in device manager. IRQs and Input/Output Range are also correct. I can also use the 3com diagnostics program to configure the cards and run test. But when I try to run the 3com installation wizard, I get an error saying "There are no 3com cards recognized".
I downloaded the software (Disk#1 and #2) from 3com web site. The date of manufacture of the cards is 1994.The 3C509 is not PnP capable as this is only available in the 3c509b.
Should I just give up trying to configure these old cards and purchase some new versions?

7 replies

by salochin

IMHO basically, seeing as the cost of a network card is so cheap, unless you are doing this for your own personal want or you are on a shoestring budget, I would purchase two new cards which would come with drivers and have more chance or working first time. Also, if one of your cards is none PNP, I suspect that it is ISA and not PCI - which would be less cumbersome to install.

by frybrian

You are correct and I am on a mission to see if I can get them working and no shoestring budget involved. These card do not have PnP so they operate in legacy mode and they are ISA. The cards are located in "Device Manger" with correct Resources and Interupt, I just cannot get the drivers to load. Thanks.

by pschuvie

Well if you ever think you might want to upgrade/replace either of the pc's to something more current the the easiest thing to do would be go out and get a couple current inexpensive and less frustrating nics.

However, the 3c509 is a little old workhorse and really shouldn't be that hard to get up and running. Most often you just happened to overlook a little step somewhere. Run back to the 3com site and download the manual which is in pdf format and go over again what you have done and also look at the troubleshooting tips. Often times it is a resource conflict since the old cards didn't have to be competing with so many other things. Especially sound cards. Most often you just have to move the irq's around. Don't forget that on board ports, ie coms can be in conflict even if they are not physically being used.

hope that helped.

by frybrian

There is an easy way out, I agree. As you say, I would just like to get these "Old work horses going" if I can. I have already download the PDFs and installation guides from 3com. I think that the Wizard is just not campatible with the non PnP Legacy boards. Thanks

by richard_barsby

Hi have u run the preinst program befor loading any drivers. I have 3c509 combo which unless you install correctly will not work.

Rich

by frybrian

I did run the Preinst and everything goes fine untill I get to the 3com installation wizard. Thanks

This discussion is closed to new replies.