Discussion Locked

3com 574 NIC PCMCIA and WIN2k

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have one of the aforementioned cards in my inspiron 7000, on which i'm running w2k. I have netbui and tcpip loaded. I can browse my internal network through netbui, but cant get outside, nor am i receiving an IP address from my freesco router. I know this port CAN receive an IP as my toshiba w/ win/me and my vidserver w/ XP all get ip's if i release it goes to all 0's if i dhcp it comes up w/ the 169.x.x.x if i assign a static IP it will maintain that ip but STILL not allow internet browsing.to test the static ip i used VNC to view the laptop. i have stripped out the drivers for the nic and the protocols to no avail. the NIC drivers (per 3com) are the native win2k drivers HELP!

2 replies

by col1n

If you checked BIOS for interupt conflict for legacy and checked plug and play in the bios also reset config data in bios then has the machine been on another network? it may have ip DNS etc for other locations so go to server dump all dhcp wins reinstall network card from scratch and set it for novell then remove novell and see if that fixes it it seem as if it is acting as an ARP broadcast usually that means os sees no card sometimes happens on 3com best of luck hope this helps.

by col1n

Dont forget to disable infra red when doing changes and re-enable after all working

This discussion is closed to new replies.