Discussion Locked

56K for the Remote User

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Our current modem bank of US Robotics 56K analog modems connected to a NT RAS server, only allows outside users to connect at 26K. All modem settings are configured to allow the maximium rate. We were told by our phone service provider that we needed digital modems on our end. What hardware should we be considering in order to support a full 56K connection for those remote dial-in users that do not have the benefit of broadband yet?

2 replies

by deadly ernest

I think your phone service provider is trying to see you off here. Modems are so essentially basic that they should work at full speed on almost any line. They are very little further advanced than the mid 1800's telegraph wires, they just make faster connects and disconnects for their dots and dashes.

Provided the modems are working and they are both using the same compression protocol you chould be getting around 40 to 50 kbps. Physically any standard copper wire telephone line in good order will only allow 33.6 kbps, the higher speeds with the 56k modems comes from the sue of a compression program.

cConnection at 26K only would normally only happen due to one of four things:

1. conflicting protocols in the modems resulting inaslowing down until they agree.

2. crappy telephone line that cannot handle the traffic, in such cases you should get bad audio on it when making a normal phone call.

3. poor modem settings at one end ot the other, both your modem and the other fellows have to be capable of the higehr speed and set up right.

4. crappy gear in the telphone switching system not able to handle the linkage properly.

So if your end is set up right and your clients are set up right, then it has to be the phone service provider giving you crap lines.

Take a modem to another site and try to connect to a dial up internet service, if you get a good connection then it is not your modems.

This discussion is closed to new replies.