Discussion Locked

A Drive format issue

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am working on a Toshiba Satellite Pro 430 CDT. The a drive will spin, but a message will appear that says "the disk in drive a is not formatted". The a drive had been used in the past to store files and this has not been a problem until recently. The drive is recognized, it spins, the driver is installed. If no disk is in the drive, the message will appear will say there is no disk in the drive. No matter what I have tried the same message still appears. Any suggestions?

7 replies

by tlccomputers

Sounds like possible misalignment of the read-write heads. The heads are unable to read the tracks on the disk. Unless you have test disks required for performing head alignment, you would be better off replacing the drive.

by ridire

The answer above may be right, but you might also want to try:

Changing interfaces. As I recall, the Toshi's can take floppy drive externally on a cable and housing from the left side of the book, or internally in place of the CD ROM. If this is true, check it in both locations, and see if you get the same response. May be an interface issue that works one place and not the other.

Also, is this the only floppy drive attached or are you trying to use more than one?

--Paul

by mgclassy

It sounds like the HD is corrupted .try a scandisk\all if that doesn't work it probably needs to be replace

This discussion is closed to new replies.