Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My A drive is installed, but when I try to use it I get a message that the drive is not available. This happened when I went through the confirmation in the setup mode.
3 replies
by jschein
did you just put this system together?
Is the light on? - Cable on backwards
Did you go into the bios and enable the A drive?
Power cable plugged into it?
by thechas
Assuming the drive is properly connected, you may need to install the IDE driver for the chip-set on your motherboard.
This is very true for Windows 98 and Me.
If the driver is not the problem, could you please give us some system details?
Motherboard
Version of Windows
Other hardware connected to the system.
Chas
by mark110a
Depending on the size of the Hard Drive and the Age of the motherboard there may be a BIOS limitation most older MB will not see above 32GB(check the hard drive instructions for a limmiting jumper to drop the size of the drive)or try looking at the motherboard manufacturers web site for a bios update.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies