Discussion Locked

ABIT BX133-RAID motherboard

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Just bought this MB for the RAID capability. Currently running NT4 sp6 and mirroring two Seagate 20GB drives. Can any of you tell me if there is a easy way to know if one of the drives in the array have failed (without rebooting the machine?)

4 replies

by thmiuatga

Yo RedEyes;
Yipe! this is not an easy nut to crack.
since you're running raid config 1 I'm wondering if you can access the drives independently at the NT desktop. If so then check the performance info on the drives to see if both are working properly. that would be right click on my computer,properties,Device manager,disk drives. click on the drive and click on properties. You should get an indication here on if the drives are working or have failed without a system reboot.

Good Luck!

by redeyes

I'm ABIT (pun intended) disappointed that I didn't get more comments from other owners of the board. (as they say, misery loves company...)

O.K. GFullTilt -- you get all 300 points!

by redeyes

News flash -- I finally got a reply from the RAID controller's manufacturer, Highpoint (no reply yet from ABIT). They claim that they will EVENTUALLY have a RAID utility that will actively monitor the status of an array while running the OS, with warnings in
case of a disk failure, and an event log. But for now -- nothing. I'll leave the question open to collect more input and then award points to the best comments...

This discussion is closed to new replies.