Discussion Locked

Abit KT7 / VisionTek geFORCE 256 Probs

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I submitted basically this same question to VisionTek customer service and pretty much got told to contact Abit. Just from past contact with Abit, I figured I'd go through here first -

Anyone know of an AGP driving value to use with this motherboard/video card combo? I think right now it's set to 'auto', but... after Windows ME loads, the monitor will randomly blank out and come back. The 'blank out' lasts about half a second - it's like the monitor is almost shutting off and turning on, butI know the problem is with the video card. VisionTek suggested I contact Abit to get a valid AGP driving value.

Any help? Thanks!

6 replies

by montea7

Almost forgot, I had problems with an older TNT2 M64. The site I eventually wound up at had more driver versions than any other I had been on, I worked through 5 drivers before I found one that worked without any glitches. May want to try it also.
www.reactorcritical.com

by wyldchilde

This is kind of unrelated to drivers, but you might try disabling power management in the BIOS, making sure the card isn't sharing resources, checking mb docs to make sure the AGP slot is getting 3.3 volts at 6 amps, and getting updated drivers for the motherboard. Additionally, you might try disabling AGP 4x or AGP Turbo in the BIOS and adjust the AGP aperature to 64 or half the system RAM.

This discussion is closed to new replies.