Question Locked

Abnormally slow Windows Installation

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I got thrown in my tech position, and I'm having trouble with a new Windows installation. I have a Dell Desktop 3000 series, and I recently bought a new WD 250GB IDE hard drive to replace one that crashed. It origianlly had a 160GB HD. I partitioned the drive and installed all the drivers, but I've been trying to install Windows for the last...six hours now. Does anyone know what causes this, and how to fix it?

9 replies

by w2ktechman

Do you have it set as master or cable select. If cable select, where on the cable is it plugged in to?
Also, you can run diags on the HDD from the BIOS (most likely). See if it is a bad drive.

by mr.wiz

and see if the CPU is set to compatibility mode. That will really slow one down if it set. If it is, reset to Normal.

by asmilindog

Have had same problems. The fix is simple. Interrupt the install and start over but first REMOVE THE BATTERY from the MBoard for 30 seconds. Then replace. Then reset clock and date in bios on restart/reinstall. You will find your setup files copy in 15 minutes rather than 2 days. Works for me everytime.

by janzer158

Your suggestion to check / switch the CPU from compatible to normal worked amazingly. My pc was soo slow after a reinstall of XP. I spent 8 hours on chat with Dell support and they had no idea of the problem. Outstanding, thank you very much, it flies again with great speed.

by dominic1967

It worked for me as well. I had tried a repair install on a noisy HD that tested good. Setup took way too long, so I tried a fresh install with a new drive. Same results. Switched out any possible component- optical drive, RAM... this trick worked, but why? What gets changed when going from "compatible" to "normal" and how does this affect a windoes install? Is this only a Dell issue? I was working with a Dimension 4600.

by striders

Dell Diminsion 2400 worked like a charm thanks

by bartonbeyer

This worked for me as well! Thank you sooo much! The XP install was so slow and it ran so slow after the install that I was about to go caveman on the case! But there was nothing called "compatibility" or "normal" mode in my BIOS, but I think it had something to do with the "CPU Internal Cache" that I enabled. It's probably the same thing, just some mobos call it "Cache" and some call it "Normal." Disabling the cache is the same as turning on "compatability" mode. At least that's my deduction.
I had turned this off because I was getting crashes left and right when trying to reinstall Windows onto any of my 3 hard drives, after it was off, Windows installed fine, just really really slowly. Now that I re-enabled the cpu internal cache, everything's running quick as lightning!

This discussion is closed to new replies.