Question Locked

Acer 5920 Bios problem

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My acer 5920g laptop was working fine and had the latest bios 1.3818. When i saw that the video memory was fixed by the latest bios to 8mb fixed(non changeable).

I used windowsxp and flashed the bios to an older version of 1.3508. After which now my laptop led's are on but nothing can be seen on the screen(blank). I gave it to the acer people but they told me that i may have to change my motherboard. Please help me. I tried using blindflash by using a pen drive but wasnt successful. If somebody can help me or make me a crisis recovery disk iso format to download i will be very thankful.Hey i think i am unable to make the crisis disk right and that my procedure is wrong.can u give me tips to do it and Can you please make me an image of a crisis disk with the bios of my acer 5920??

2 replies

by oh smeg

The BIOS Chip [b]Basic Input/Output System (BIOS)[/b] is part of the M'Board and as such can not be replaced easily.

If if has been attacked with the wrong Instruction Set and its contents changed because all it is a a EPROM [b]Erasable Programmable Read-Only Memory[/b] there is now no way to reprogram it available so the standard response is to replace the M'Board.

Didn't you read the Warning about Flashing the BIOS on the Makers Web Site? There is no need to make changes in this area unless there are current problems with the system like it doesn't support the installed CPU. Updating the BIOS just because it's there is fraught with danger which you now see.

If you have access to a Surface Mount Soldering Station it may prove possible to replace the BIOS IC but these are horrendously expensive while the IC's themselves are not. It may also be possible to reprogram the IC with a suitably modified EPROM Burner that allows you to connect directly the the IC on the M'Board but if you get 1 connection wrong you will fry the IC and be back where you are now.

If you want to try replacing the IC you can purchase a preprogrammed one here maybe.

http://www.biosman.com/

Of course if the EPROM is in a Socket it is a easy thing to replace but most NB's have these soldered directly to the M'Board to prevent movement which would result in failures.

Col

This discussion is closed to new replies.