Discussion Locked

AcerView F51 not display Splash screens

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
This annoyance has been a bother for over a year. I must find a way to fix! Have an AcerView F51 flat panel monitor that does not display the startup or shutdown splash screens. This also means that I can not see bios screen or command prompt in full screen mode. If I hook up a regular crt all is fine. I have updated drivers but no difference. What I have: Clone pc 650 amd on Win98 se plus. Using Ati card with 32 meg. It used to work on old Clone 200mhz machine, then one day it stopped. When Iinstalled on new 650 machine it did not work form the start. No help from Acer or ATI. Startup sequence: I get basic post test to monitor (ram check and p+p detection) then screen goes blank. No error beep for monitor and power light on monitor remains green. When windows finishes loading (at point where wallpaper is loaded) screen displays normally. One final observation, when machine starts up (or reboots) I get "no signal" display on monitor then a blank screen. Then what appears to be a glitch in the display, like it is changing the resolution, they the begining of the post test displays. Any thoughts or ideas? Thanks in advance.

3 replies

by csmith

This is a rare problem, but I have see both monitors and video cards "get stuck" in svga modes.
Since you said the video works fine with another monitor, it must be the monitor.
I don't know if it's power surges, a manufacturing defect, or some other cause that creates this problem.
I don't know any way to fix this problem.
If it is under warranty, return it.
If it is out of warranty, we usually install the "stuck" card or monitor in a location with a stable configuration (A computer used mostly for word processing , internet surfing, etc.) , or a machine that is almost never turned off (server) and "live with it".
Regards, Chris , csmith@smithandyoung.com

by csmith

:
By the way,
The "Glitch" you see is the video card changing from VGA mode to SVGA mode.
(Remember the boot is in VGA mode.)
The monitor can display SVGA. It is the VGA mode that it can't switch to. When the Video
Card switches to SVGA,the Monitor can handle that, so Voila! the display appears.
Regards., Chris

by estebandelatorre

That's not a common problem, monitor should work under DOS mode properly.The best place for that kind of problem will be The Acer help desk.

Hope it helps!

This discussion is closed to new replies.