Discussion Locked

Add a port to existing system? How?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a man needing to add a palm top to his system. It doesn't have the port available to hook it too. It needs a port that looks like a serial mouse port. What is the easiest/best way to put a port in and will Windows 95 see it or will it haveto be configured?

Thanks in advance,
Michelinda

5 replies

by todd

Get a PCI serial card. The card should have settings on it to contol the address and interupt. You will need to use a different address and probably its own irq. Windows95 will probably need it to manually added using the add hardware wizard without a scan. Goto to the ports section add a serial port. It will give it a address and irq. They will probably be wrong. Thats OK. Just reboot the system. Goto the device manager and change the properties of the new port to match what you board reflects and reboot. That should do it.

by contra-heald

If you dont have a interface(connnecter) on your motherboard for additional serial ports, you will need an expansion card to install additional serial port. First you must identify your type of slots. most newer cpu's have "PCI" slots and or "ISA" (8 or 16 bit) slots. refer to your manual if you have one. Either way you will have to open your computers case to see.

This discussion is closed to new replies.