Discussion Locked

Add Sblaster win98 machine/w novelclient

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After adding a sound blaster128 to a win98 machine with novell client 4.1 on it. It will no longer login, it just locks up, it will boot up if you cancel logon. Take the card back out and it logs on again. There are no conflicts in the irq's. Removing the client and reinstalling does no good, still no communication with the network. The soundcard works every time. I have also checked the irq of the nic and the soundblaster card when installed, no conflict. These are pentium 200 mhz mmx with 3-com 3c9x nic's, with 3 isa slots and 3 pci slots. The cmos is set to auto and pnp is turned on. Award bios with via chipset. Anybody got a clue?

3 replies

by csmith

You are correct that this is not a IRQ conflict. The most likely suspect is a "hidden address conflict". The hidden address conflict is where, due to an engineers error in the chip logic, the card uses a wider I/O address range than stated in the manual or in the .inf file. This is an old problem. Even IBM had a case of it with their VGA adapters using more than C000-C800 in UMB. (This was about ten years ago.)
This is easy to test. Just go into the Device Manager, and manually force the I/O address of the sound card or NIC away from anything close.
I have never experienced this problem, but I have had other technician friends talk about this problem in certain 3COM cards.
Regards, Chris

This discussion is closed to new replies.