Discussion Locked

Added more RAM, now CPU won't start

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an Intel Celeron 1.4 Gig computer, running XP,
with only 128MB RAM. Computer was a little sluggish
and so I went out and got more RAM. 512MB of RAM
today, that's the max amount of RAM for the CPU. I
took out the 128 and put in the 512. I went to start
the computer and it starts normal for about 2 secs.
and then nothing. I hear one beep and normal lights
on front of CPU at first. Then the CPU is just "on" with
nothing happening. The back fan is on if that means
anything.

Then I removed the new RAM and put the old RAM in.
The same thing happens and the computer won't
start. The computer worked fine up until 40 mins ago.
Any ideas would be extremely apprciated!!!!! Thanks!

5 replies

by thechas

Best guess, the new RAM is not compatible with your motherboard. It is either too high a density (chip-design) or is too fast and cannot be properly addressed by the BIOS.

Try clearing the CMOS RAM.
This usually involves changing the position of a jumper on the motherboard, boot up, shutting down, setting the jumper back to normal.

If that does not work, make sure that the RAM socket is clear of dust or lint, and that the RAM is FULLY seated in the socket.

Make sure that you did not loosen any cables or plug-in cards.

Did you shut off ALL power to the PC when you swapped the RAM modules?
Most ATX style PCs still have voltage on the motherboard when you shut them down. You need to either shut off the power supply, or un-plug the PC to ensure that power is off when installing parts.
Also, did you follow anti-static precautions?

If the answer is no to either or both of the above it is possible that the RAM modules or the motherboard have been damaged.

Chas

by house

Long beep is bad or unrecognized ram. But if it was bad, the computer wouldn't even start like normal and the beep would start the instant you give it power.

Since it won't work even with the old ram, you probably zapped a chip. You wouldn't even have felt the shock either.

I never work with antistatic, but I have been very lucky. I've only killed ram at work. I give thanks to a good warranty.

by rindi1

Maybe you just moved the graphics card a bit when you changed the RAM. Make sure it is seated well in its slot. Best thing is to remove all cards and push them back in. Also make sure the cables of your IDE drives are seated correctly.

by dcosgrove

%12 is probably the total max ram. If you have two slots, that means 256 in each slot. You can check pretty quickly by going to Crucial and going through the upgrade wizard. It wiil tell you everything you need to know.

by otl

In addition to answer # 1, ask the system how much ram is in it. Go into the bios to see how much it says it has.

May even have to clear the bios to get it to recognize the old ram, done by removing the battery for 30 sec - 30 min.

Also agree that RAM may not be properly seated and that is the root cause of the no-boot syndrom. Thus reinstalling the 512 may be enough to get you up and running.

This discussion is closed to new replies.