Discussion Locked

Adding 2nd SCSI hard drive

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm upgrading my NT4 server to Win2k Server. I want to add a new SCSI drive as the master and install 2000 on it and use my existing hard drive for data/IIS. Is this pretty easy to do, I've done hardware for years but never added a 2nd drive to a server.....so don't laugh at me :)

5 replies

by mckaytech

No laughing here... even the experts started with a first time.

First of all, in the SCSI world, there are not "master" and "slave" drives like in the IDE world. SCSI drives are addressed with number between 0 and 7 (or 0 and 15 depending on thegeneration of the controller) and the only "gotcha" is making sure that you don't have two devices set to the same address. The unofficial convention is that the SCSI adapter itself will have the highest address and the drives will start from 0 and work their way up.

So everything will probably work fine if you setup the new drive as SCSI 0, the existing drive as SCSI 1. The W2K install is pretty accurate with hardware detection so it should be an uneventful installation from that point (particularly if you have a brand-name SCSI controller).

One important point is that if the existing drive has NTFS partitions, they will become unavailable so if there is data on them, you'll need to back it up to something and do a restore after you've done the W2K install and created and formatted the new partitions.

regards!

paul

by dogdrake

All that you need is a boost of confidence. I did this process of adding asecondary drive on scsi and it was like the pc sec. master, just get correct jumper selections of configurations.I think you have it.:)

This discussion is closed to new replies.