Discussion Locked

Adding a 5th IDE device

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I currently have four IDE devices on my PII/300 mhz PC. I want to add a fifth IDE device. Can I do this? I have a DVD/CD, Sony tape backup and 2 hard disk drives.

I want to add a CDRW drive.

11 replies

by dennis_herr_jr

Yes. I have a similiar setup with 5 IDE devices. I added a Promise ATA100 IDE PCI card to my system to get the extra connections.

by mmirtes

You could always install a IDE RAID controler. This would allow you seperate your hard drives from your other deivces.

by albert franco ii

As mentioned by the other two responders you must add an addition controller. I just wanted to add that the CDRW should be put by itself on one of the four IDE channels. This will reduce the chance of buffer underruns.

In any case don't put it on the same channel as any other other device which will serve as a source for recording.

by csmith

Installed a Maxtor UDMA controller yesterday (Same as Promise) in a PC with a Epox 8KTA3 motherboard. Plugged in the CD-RW to the card and the BIOS (AWARD) would not boot or recognize the card without a hard drive also attached to the other IDE channel on the card.
Just a minor nuisance, card works fine.
Just so you are forewarned.
Regards, Chris

by cdb

Like the others said you have to add a controler card. Since it is a cdrw you want, I would put in an inexpensive scsi card. You can get older models cheap. Scsi is a much better chanel for cdrw.
Chris

This discussion is closed to new replies.