Discussion Locked

adding a hard drive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
what steps do i need to follow to add another hard drive to my desktop pc and have it recognized as a separate drive?

7 replies

by dmiles

Check the drive manual for instructions to set the jumper pin configuration to set drive as slave or master

Check the current drive jumper setting also,the setup needs to be one master and one slave

Install the drive in system and when the startup screen appears,press the key to enter setup to bios,in the advanced configuration panel select the slave drive section and set to Auto,save and reboot

After reboot,double-click on My Computer,select the D-drive and right-click and choose format or use the setup disk that accompanies the drive.

by thechas

In addition to waht soulrider gave you, you will need to partition the drive before you can format it.
This is done with the fdisk command.
I recommend doing this from a boot floppy with Windows 9X or Me. You can do everything from disk manager if you are using XP.

Your Operating system and existing drive setup need to be considered before deciding how to set up the partitions.
If your existing hard drive has more than 1 partition, and you want to keep the drive letter assignments, do the following; (Assumes W98 or Me)

Using a boot floppy, boot up the system.
from the dos prompt, type fdisk press enter.
Answer Yes for support for large drives.
Select option 5 to choose the new (slave) drive.
Choose option 1 to set a partition.
Chose to create an extended dos partition.
Choose to use the entire drive.
Now you need to create 1 or more logical drives in the extended partition.
For W98, I recommend that you keep the drive size below 30GB. So, with a 40GB drive, you will create a 30 and a 10GB logical drive.
Exit fdisk, and reboot to windows.

Format the drive(s)

Note: Your existing (master) hard drive will be drive "C". (and the next X number of drives if it had more than 1 partition)
Your new drive will be "D" (or "X" +1) and the following letters for the number of drives created.
Your CD-ROM drive(s) will be the next letter after the last logical drive on the second hard drive.

For more information on fdisk and partitioning, check out www.aumha.org
The

by mintsauce

all of the above is correct for a win 9x ME system, But if using win NT4/5 then the operating systems have their own disk programs nt4 (windisk) and nt5 (diskmgmt.mgk) for win 2000 win xp easy to follow instructions you really cant go wrong

This discussion is closed to new replies.