Question Locked

Adding a slave hard drive under win 98

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an old pc with win 98 on it. (Viglen pentium II 128mb ram and 4 gb hard drive). I have added a 5gb slave hard drive (already fromated with data on it) but the system does not see it

How do I get the system to see the hard drive?

5 replies

by ozi eagle

Hi,

First double check your jumpers to make sure its set as a slave.

The other thing is whether it has been formatted as NTFS. Win98 cannot read an NTFS disk. (ie did the 5GB disk come from a W2K or XP machine?)

Herb

by absolutely

So, my first guess is wrong, and your problem should have nothing to do with the old '? GB limit' of Windows 95 & 98.

http://www.microsoft.com/technet/prodtechnol/windows2000serv/reskit/core/fncc_fil_tvjq.mspx?mfr=true

Do both drives appear in BIOS? Are you sure you put the jumpers in the right place? Any chance one is set to 'cable select' rather than master or slave? Cable select only works if both drives on a channel use that setting.

by grassiap

enter the bios, check if the second drive is seen correctly. to be sure there should be a "detect IDE channels" or something similar available.
As I guess your second HDD is on the second IDE channel, make sure it is enabled in the bios
look for the CHS numbers on the label of the HDD and make sure that they are what the bios detected. worse case scenario, you would have to get the bios autodetect the HDD config at each boot. Takes a handful of seconds more at each boot but this is usually a very safe settings.

Check the jumpers, make sure it is set to "slave" if there is a master on the same channel, and that the master is actually set to "master" and not "standalone" if the options are different for "standalone" and "master"
as well I encountered in the past a situation were a faster slave prevented the slower master to actually handle the bus. this usually prevented the system to start.
if your second HDD is alone on second IDE channel make sure the jumper are set to "master" or "standalone"

finally if your second HDD is NTFS formatted you should see the drive letter but not be able to open it. Then you'll want to download the NTFS driver for Windows 98 by sysinternal
just google ntfs98 and pick your preferred.

The free version offers only read access. I do not know what happened to the paid (i.e. write) version since sysinternal got acquired by MS.

HTH
Philippe

by Member 29565599

Thanks folks it was all to do with the jumpers and the bios setting that needed setting to auto

Up and running now

Just need to find an old 128 mb mamory card I have somewhere and then I will have a workable m/c for my son to do his homework on -

Thanks

This discussion is closed to new replies.