Discussion Locked

Adding an extra hard drive

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm having trouble adding another hard drive, I have phycially set the drives to master and slave. Not to sure what to do in the BIOS, I have selected both the drives to auto detect, without success. After re-boot it does not find any HD and says 'operating system not present'. I have also manually added the correct cyclinders, heads, scl details for both drives but the above error occurs. As soon as I remove the extra drive everything is ok. The extra drive is sharing the same cable as the primary drive that is attached to the motherboard (there is another connector on the end to attach another HD) I have no spare port on the motherboard to use.

9 replies

by dmiles

Reads as though the new drive is being detected as the Master,check the diagram on the drive and make sure that you have the primary drive jumper set to master and the secondary drive jumper set to slave,make sure cable is orientation is on pin correctly.
open the CMOS control panel and select the auto detect,save and exit.
Partition and Format the new drive using the setup software or using fdisk.

by fenaikh

Hi
pls do:
1-Detach the master Hd and attach(confirm that red stripe to pin 1 in both motherboard and HD and the cable is fitted in all pins,some time only one side this happen) the salve as master HD and set the bios to auto(pls make sure if yourmother board support the size of your HD, and LBA or set it manually if nessaserly)then boot with a floppy.if you can access the HD then do fdisk to partion it if needed then format it.
2- If the slave HD is WD and the master is not WD Make the WDto be the master.
3-make sure that the jumbers are set right and the master drive in the end of the cable.
4-Change the cable with another cable.
I hope this will help you.iF You need more info pls smg to me.
good luck.

Mohamed

by jwpluto

Depending on the mfg, there are a few pc's that use the cs (cable select) setting on the master hard drive. Compaq and HP are known to use these, among a few others. When you add a drive, you may need to set the master to "CS" and the slave to "slave".

by s.o.f.t

You could try changing the new hd to a master and use the same cable as your cd rom

This discussion is closed to new replies.