Discussion Locked

Adding an IDE hard drive

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The server I inherited has two (2) 9 Gb SCSI hard drives. I am trying to add an 80 Gb IDE hard drive just for storage. When I connect the IDE drive the server pases the POST tests and hangs at the next screen. Without the IDE drive it boots fine. The bios shows that it should support this drive by the date and version numbers per the manufacturers web site. Is the server looking at the IDE drive as if it is the Boot drive? If so how do I get around this?

8 replies

by thechas

Yes, the server is likely looking to boot from the IDE drive.

Also, by default, all of your drive letters have changed. So, even if it is not booting from the IDE drive, it is looking for the files on the wrong drive.

Several things that you can try / check.

Make sure that the IDE drive is not formated as a bootable drive.

You may want to set the partition as inactive.

In BIOS settings, make sure that SCSI is in the list prior to IDE.

Other options:

Instead of using the on-board IDE controller, use a plug-in controller. It may take some slot swapping to have the IDE controller load after the SCSI controller.

Install the IDE drive as Secondary Slave.

Partition the drive as only an extended DOS partition.

Re-install the server OS, and take into account the drive letter changes. (you may get by just editing the Boot.ini file)

Chas

by darryl

Thanks, I already tried some of suggestions. I will try the others. I took for granted the bios was set to boot to a SCSI drive but I did not check it. I was in brain block, thanks again.

by zlitocook

What is the server, HP, IBM, COMPAQ? How old is it, you may need bios upgrades. Did the bios see the new drive and the size? Check with the maker to see if it will support an ide drive. Try the drive in another computer to see if is a good drive. A brand new drive can be bad out of the box. There should be a place in the bios to tell the computer that it has scsi and ide and to detect both.

by darryl

It is a generic box. Yes the bios saw the drive and size. The drive was tested on another machine and it is a good drive.

by techkid

I think if the system was trying to boot from the ide drive it would give an error message that the os couldn't be found or something like that, it wouldn't hang. Try checking the settings though.

As mentioned already, I would try upgrading the bios, use a different ide cable, try plugging the drive into the other ide slots.

by darryl

I tried other slots and even slaving it behind a CD Rom and the same thing happened. I will try the bios settings and I think that may be where the problem is.

This discussion is closed to new replies.