Discussion Locked

Adding Network printer.....

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to install a Canon ImageRUNNER 600 Copier/Printer, etc.. to a local network.
Here is the current setup:

Cable Modem-->Netgear Router(RP614v2) 4 port.

3 8-port 3Net Switches-->Router Ports 1-3

The Canon machine is connected to the 3rd Switch...how can I detect it or install it?
Should I connect it directly to the Router?

11 replies

by cyberghost_1

Yes I got that far, the problem is how do I configure the router to detect the Copier/Priner.
i.e. IP, and so on? The router doesn?t detect the Copier under ?Attached Devices? I only see the 10 PC in the network. Also I think I need to assign a Static IP to the copier...
I can?t find the configuration from the Copier itself to assign an IP...

by dustyd

If it is indeed networkable, go here to download the setup for the 600V.
http://tinyurl.com/4mzts

I once tried the same with an ImageClass, but didn't want to buy the proprietary NIC card for the printer. I finally gave up and installed as a shared printer attached to a PC.

If the setup above doesn't give you access to configure the IP, then you probably will have to go the same route.

by glyall

can you get a configuation page printed out?

it should give an IP address and a host name.
if you do not have a print server you have to
configure a standard TCP/IP port to set up the printer on each PC/Laptop to print to it.

hope this help
good luck

by rcom

To get into the I/O config you need to turn off the unit and turn it back on and wait for the setup option to appear. It only lasts for a few seconds. Look behind the unit for the instruction manuals there's usually a pouch for them.

Canon has software that can configure the nic and setup ports on the PCs. Look through the available choices.

http://www.canonusa.com/html/download/canonnetutils.html

This discussion is closed to new replies.