Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a IBM x-series server here in the office. It uses RAID 5 with 3 SCSI hard disks with similar make and model. I need to expand the HDD by adding in maybe 1 or 2 more SCSI hard disks. My question is, can I just add in the new hard disk just like that and expect the controller card to do the rest of the job without over-writing the data already in the existing hard disks ? If it is not, how can I configure the RAID to include the new hard disk without damaging my data?
7 replies
by timwalsh
USUALLY, the RAID controller WILL take care of integrating new disks into a RAID array. There may be utility software that you must run to help accomplish this. Look through the documentation of your specific RAID controller for the specific procedures.
by singh_vb
The question was auto-closed by TechRepublic
by paulp
I only have experience on Compaq servers running Netware. Just adding a hard drive is not an option. The entire array has to be rebuilt.
You didn't mention what OS you're running. It may not be the same situation.
If this is a production server, I wouldn't attempt this until I knew EXACTLY what to do and what to expect and had a PROVEN reliable backup.
by singh_vb
The question was auto-closed by TechRepublic
by djent
That would be a function of the raid controller utility, check the controller DOCS.
by singh_vb
The question was auto-closed by TechRepublic
by singh_vb
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies