Discussion Locked

Additional hard drive problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have been given a 3GB hard drive to add on to my Packard Bell Pentium II PC motherboard to boost the measly 5GB Hard drive already installed - the PC is 5 years old now and i want to build a new PC later this year when i have more confidence! I slotted in the "new" hard drive that apparently has partitions on it - which i was told i could use the FDISK option to resolve.
My main problem is that once installed i get the black screen of death - i have set the jumper to Master for the original hard drive and slave for the addtional hard drive. The orginal hard drive has been split into C:\ D:\ E:\ and G:\ by a local computer shop when i had problems upgrading to Win98 SE (i didn't ask them to do that though!!)

I think it might not be possible to add another hard drive to this type of PC so would i be better buying a single larger hard drive to replace the orignal and set it as the master? I was told some time ago that this type of PC is a pain to upgrade.
I need advice before i go insane LOL

5 replies

by thechas

Here are some things to check:

1. Is the IDE cable reversed on 1 drive.
2. Sometimes, drives made by different manufactures don't work well as master and slave.
Try seting the new drive as master, and the old drive as slave.
If you now can boot the PC, you need to transfer the operating system from your old drive to the primary partition on the new drive.

I would recommend against putting a large hard drive in this system.
It likely has limited support for large hard drives. (perhaps 8GB is the largest supported drive)

I would wait until you are ready to assemble your new system.
To improve the odds on your first PC build, try to work with 1 dealer for all the parts. That way, you reduce the finger pointing to other vendors.
Consider a "bare-bones" PC. That way, the toughest of the mechanical assembly is done for you.

Good Luck, and enjoy,

Chas

by gigelul

Hi,
Other options is to install the additional HDD on secondary IDE as master and CD-ROM if exist on primary IDE as slave or on secondary IDE also slave.
Both HDD are correct indentified by BIOS? If yes, using these combinations you will be able to use both HDD.

This discussion is closed to new replies.