Discussion Locked

ADSL

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm using a Compex NetPassage15 router and I'm trying to connect my ADSL modem to it to route to my network. However, everytime i connect the modem to the router my network goes haywire and I can't even ping the router. What could be causing this?

9 replies

by buffalodan

It's similar to connecting a router to a router...except you ADSL device does not use an uplink port.

Are you using a crossover cable or a straight thru patch cable?

by ebob

You likely need to use a roll-over cable between your DSL "modem" and the router's ethernet port.

Note that a roll-over cable swaps pin 1 at one end for pin 8 at the other, pin 2 for pin 7, etc. This is DIFFERENT than a crtoss-over which swaps pairs of pins in a different manner (something bizarre like pin 2 for pin 3, pin 4 for pin 7, etc.)

by vertex

Crossover cable is what you need, but the Compex NetPassage 15 don't require a crossover cable. On your uplink port there should be a tiny white switch that you need to push in if you are not using any Xover cable.

by n1ipa

A site you might to check out that has alot of DSL information where you might might some one in there message posting that might have a similar setup is www.dslreports.com
the site has alot of good information about the different things that might be of some help with this.

This discussion is closed to new replies.