13 replies
by dmiles
To what basis or documantation are they basing their accessment on,to support that that the technology is filmsy,sounds more like a blanket statement,rather than saying they donot have the knowledge to repair or support the product.
Try looking at the product manual to see what suggestions it gives on what type of storage media to use before spending.
The speed of the drive compared to the rewritable disk speed should be compatable and will be a determining factor.
by shanghai sam
I don't have the product manual. It came installed with the computer. A more helpful reply would be something like "RICOH is a reputable manufacturer. 1st, try visiting their website for online advice. 2nd, maybe lug your (2'x1.5') tower to a different computer repair service and let them test/repair or replace the drive. Here are some good bargains that I know of ..."
Thanks anyway for responding,
Percy
by madmark
I have had very few problems with my CDR/DVD. I did have some problems when using CHEAP CD's!! You know, the Wal-Mart 50? special kind. I actually had a couple of these babies EXPLODE in my drive bay. Scared the living daylights out of me. It was due to flaws in the media, airbubbles...
My teenage son has had issues after formatting his hard disk, he couldn't find his original Dell installation CD and had to scoop s/w off of the internet. He had issues getting anything to work right until he started using NeoBurn.
My recommendation is always spend that extra $50 to get quality name brand hardware, doesn't have to be the fastest one, and then spend the extra few pennies on quality media. Oh and backup often, and wear clean knickers...
by shanghai sam
As I said, I have a RICOH drive that came with the computer. I have several Memorex and TDK disks, most of them unopened since the first few didn't work. If I tried them all, maybe one of the bunch would work - what I meant by flimsy technology. What brand of drive is in your system? What brand of CD-RWs do you use?
Thanks for responding,
Percy
by thechas
In my opinion, the comment about flimsy technology was an attempt to get you out of their hair.
They just didn't want to deal with your system.
I assume that you did not buy it from them.
I would avoid combo DVD player CD-RW drives because you are asking a lot out of one laser/ piece of hardware.
I have had problems with my seperate DVD drive to the point where I decided to have 3 drives;
CD
DVD
CD-RW
Of the CD-RW drives that I have, the HP and Philips drives seam to be the most reliable.
I also have an Imation and Hi-Val (no-name) drive. While I have not had any specific problems with them, they just don't seam as well built as the older drives.
In a previus post on CD-RW drives, Plextor was the most recommended brand.
As to media, there are variations.
For a while, I was having problems with Imation CD-Rs, it turned out to be an IDE driver and CD-RW drive firmware issue.
I have had several RW disks just fail on me. My best recomendation is to shut down all other programs. Some systems and CD drives have conflicts if any resources are in use while the drive is attempting to write.
Chas
by joseph moore
IMHO, I don't like CDRW. I have had nothing but problems with the format.
I run CDR at home and do not plan to change.
by dmiles
Yes,I could have given you that type of reply yet I thought you were asking for another opinion
So,if you had the answer why did you post the question
No,Reply necessary
Thanks for the comments,to which I will archive for future reference
by titanpcs
While there are zealots for every type of manufacturer/producer out there, the general consensus seems to be on Plextor CDRW with Burnproof as the de facto standard for everyday backups/storage. For a company to tell you they won't service a productbased on "flimsy technology" means they know next to nothing about the drive in question. As someone else answered, they were most likely trying to get you out of their hair, as they did not want to go through the porcess of troubleshooting and fixing the problem.
Hopefully that helps,
Blake
Thanks Blake,
I will definitely look into Plextor. The byte shop in question greatly helped me get over my skittishnes with getting under the hood of my computer but I guess its time to move on to someone with a bit more expertise.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending