Discussion Locked

Asus P2E-M Mobo Only See's PII 233?

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an Asus P2E-M motherboard and no matter how I set the freq. ratio jumpers, CMOS only reads the CPU as a PII 233. I have a PII 350 in it. I tried setting the clock multiplier jumpers from 66 to 75, but it only reads the CPU as high as PII 296. Any suggestions?

10 replies

by alpha-male

The BIOS settings on CPUs don't always reflect the actual processor accurately. Perhaps if you can find a BIOS upgrade it will...but often times if you install a faster processor than was available at the time the board was made, it won't display the speed accurately.

I would recommend you run software like SiSoft Sandra and see what kind of performance ratings it gives and what specs it sees.

http://www.sisoftware.co.uk/sandra

Good luck!

by nhargrave

I think I should be able to get 333 out of the motherboard with the highest clock multiplier. I haven't installed windows on the system yet, so I can't install sandra. Thanks for the info though, I ran sandra on my main system..:->

by thechas

Per the ASUS manual, the chipset on the board is rated for 66MHz front side bus maximum.
With 66MHz, and 5X multiplier, you max out at 333 MHz CPU clock.

Per a CPU setting data sheet that I have, the PII 350 is a 100MHz Front side bus CPU, and would use a 3.5X multiplier.

Bottom line, the best "stabil" configuration for your motherboard is a PII 333.

In order to have a chance for the 75MHz bus setting to work, you would want to have PC100 SDRAM installed.

Chas

by nhargrave

I set the multiplier up to 75, then to 83, but the highest I could get was still PII 296. I have 256 megs of PC100 SDRAM installed. Thanks.

by dmiles

Check the motherboard manual and set the jumpers to 350 specs,not boot computer,at startup screen hit designated key to enter CMOS configuration panel,check to make sure that the settings are be specified correctly

Did you buy the chip from a reputable store,sometimes you can get bogus chips

by nhargrave

Unfortunetly, the motherboard doesn't go up to 350. I was hoping the bios update would fix that, but the 440EX chipset doesn't go past 333. I'm going to have to get a different motherboard. Thanks everyone.

by crapaud ergo sum

the board will not support that chip.
from the specs:
Processor
Slot 1 for Intel Pentium? II Processor 233MHz ~ 333MHz
Chipset
Intel 440EX AGPset
System Memory
2 x 168-Pin DIMM Sockets Support 8MB to 256MB Memory Capacity
Use 8/16/32/64/128 MB 168-Pin Single or Double Side 3.3 V SDRAM/ Module
On Board Audio
ISA 3D Audio Controller Onboard, Sound Blaster 16/PRO Compatible, Microsoft Direct Sound 3D DirectX 5.0 Compatible

by nhargrave

Yes, I determined this to be true. However, I still thought that I could configure the jumpers so that it thought I had at least a PII 333 installed. Think I'll keep this motherboard and get a 333 for it. Thanks

This discussion is closed to new replies.