Discussion Locked

Asus P4C800-E Deluxe Drive Detection

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a SATA Drive on SATA1 and an Ultra/DMA on IDE Controller-1 as Master and two DVD Drives on Controller-2 Master and Slave.
When I boot up i get the following message:
Scanning for IDE Drives.......
No Drive attatched to FastTrack Controller. BIOS not Installed.
Then the system boots up normally. However. this process takes time and is frustrating.
Any suggestion as to how I can avoid this message to show up?
Thank you.
Edward

5 replies

by thechas

From looking at the manual, the message appears to be from the on-board SATA RAID controller.

Since you cannot disable any of the SATA channels, I recommend that you change the IDE detection time-out to a smaller value.
Start by dropping to 20 seconds. Then step it down by 5 seconds at a time. Wait till you perform a hard cold boot (PC off for more than 1 hour) before switching to a lower time.

Chas

by cg it

In addition to TheChas's suggestion, why not just put the Serial ATA HDD on the SATA Controller? That would stop the message all together and allow you faster read/write performance from you Serial ATA drive. As it stands now, your underutilizing the hardware you have.

If your having problems with boot to the Serial ATA drive on the Serial ATA controller, try using boot SCSI / boot other in the boot up sequence. I believe Windows [all flavors] see the Serial ATA as a SCSI. I had to use boot SCSI on my MSI board to get WXP to recognize the Serial ATA drive. Further I had to create an array, even though there was only one drive and install the Promise 378 Controller drivers AND the Promise Serial ATA drivers for XP to get them to work.

by erho

My SATA is connected to SATA1, which is a Serial ATA connector.
Thanks anyway.

This discussion is closed to new replies.