Discussion Locked

AT -vs- ATX Power Supplies

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Iwas wondering if an AT power supply could be used on an ATX mother board, or if the AT power supply and mother board could be faked out.

11 replies

by grump

Some of the earlier MBD had provisions for dual power source.. Meaning you could use AT or ATX power supply.. Most of all the latest are of the ATX from factor. No you can not fake out the mother board Simply look at the power connector for the mother board, the connectors are different, and the ATX supply connector contains couple leads and lines that the AT supply simply does not have or provide.. Also with all this new stuff you should be looking at higher wattage power supply also.. SORRY but you just simply can't do it!

by guruofdos

Yes an AT power supply CAN be used on an ATX motherboard but, and it's a BIG BUT....

You will need a 12 Pin Molex connector to take the 2 6 pin AT motherboard connectors, a 20 way ATX style Molex connector and the following:- 3.3v 10 amp regulator with a large heatsink, filter capacitors and one or two other components. Some 4000 series CMOS logic, for power and reset circuitry, a pcb or proto board, 16/0.2 cable to wire it all up with and preferably a small case to house it.

AT Power supplies switch the mains input with a large 2 pole 10A switch. ATX are switched electronically so there is a problem with the case switch to consider too!

Yes it CAN be done. YES I have done it. YES it works perfectly. An ATX 350W psu can be obtained for around ?14, or US$18. The components and time to build a converter....anyones guess....I built mine in my coffee break just to prove a point to a fellow techie and the parts cost around ?17 for whatever I didn't have lying around on the bench.....

Your call!

by guruofdos

Following up to my original posting...

Believe it or not, it's actually slightly more difficult to frig an AT board to work with an ATX power supply...just in case you were wondering :-)

This discussion is closed to new replies.