Discussion Locked

ATA 33 UltraATA 66 and Ultra ATA 100

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Assuming your motherboard supports the varios ATA speeds, what happens when you have a mix of hard drives installed? In other words, if I have an ATA66 drive and a ATA100 drive on the same machine, will they both run at their respective speeds or will they default to the lower speed?

7 replies

by tbradley

They will default to the lowest speed on
the particular IDE interface the drives are
installed on.....

ie, if you have a ATA100 system board,
A C: drive ( master ) at ATA100, and a D: drive ( slave ) at ATA 66, your drive speed will be 66.
If you separate the two drives, put C: on IDE1, and put D: on IDE2, C will run at 100, and D: will run at 66.

by roland63

I opt to disagree with the first answer and say this;

If your Mobo supports ATA100, assuming you have both drives on the same bank, set it for ATA100, the drive with ATA66 will run at its ATA66 speed and needless to say, the ATA100 drive will runat ATA100 speed.

Good luck.

by c_m_s

Hi there,
Tech Republic recently had an article on this subject titled "All About IDE". It is dated Feb. 19, 2001 and author is Faithe Wempen. Should find it in Research Index or by doing a search.

Good Luck,
Mike

This discussion is closed to new replies.