6 replies
by thechas
Unfortunately, there is no way to easily verify if an 80 conductor IDE cable is UDMA66, ATA100, or ATA133.
Generally, most 80 conductor cables will support the ATA133 standard.
Some of the first 'low cost' UDMA66 cables may not support full ATA133 transfer speeds.
The only way to check it out, would be to run a hard drive speed benchmark utility, and see if any cables are slower or faster than others.
At a manufacturing level, the quality tests would involve terminating the cable withloads of the proper impeadance, and testing the signal integrity and cross-talk.
Production testing likely only checks continuity.
Chas
by europanorama
by b_pope
Since you've purchased a Maxtor ATA133 drive, whether you have a ATA133 is only going to matter if your motherboard has a onboard Promise controller or you purchase the Promise Ultra133 TX2 control card which also includes the ATA133 ribbon cable inthe package.
The only difference I noticed was the cable included with the Promise card was a deep grey colour instead of the normal beige of my other 80pin cables. I also purchased a second ATA133 cable (the package said it was ATA133) from my PC shop it also was a deep grey colour, whether that means anything I don't know.
by europanorama
by europanorama
by europanorama
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending