Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Which is faster on an ATA133 IDE controller? an ATA133 HD with 2Mb of Cache or an ATA100 with 8Mb of cache?
6 replies
by thechas
There are more factors at play here then given.
The drive seek and access speed will have an equal if not greater impact on the overall data transfer rate.
As will the size of files transfered.
If the read speeds of the drives are equal, the ATA133 will be faster.
If the ATA133 drive has a slower access speed, then the ATA100 drive will have a potential edge.
Chas
by akajoey
Poster rated this answer
by akula
Personally, I would go with the 8MB ATA100 drive. The 100 or 133 MB/sec only applies when the disk cache is full- the HD can't read fast enough to transfer at even the old 66MB/sec spec. So, with an 8MB drive, you can burst more information over the ATA bus.
by akula
The latest Maximum PC (April 2003) tested an ATA133 Maxtor drive on both a Promise ATA100 and ATA133 controller. There was almost no speed difference- not even a single percentage point difference in speed, and on a couple things the ATA100 was even faster (although by that miniscule difference).
by akajoey
Poster rated this answer
by akajoey
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies