Discussion Locked

ata66 vs ata100

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have been told that since 1999 all ata 100 hardrives are backward compatable with ata66 and ata33 machines.my machine was built in 1999 so I assume it is ata4.question is: what do I need to do to run an ata100 hd in an ata66 machine?It has a Gigabyte GA-5AX (rev 4) mainboard and has an AMD K62-500 processor.Any help would be appreciated.

9 replies

by sgt_shultz

you tell the drive which to use. give the drive model and we can be more specific. but usually the drives come with, or you can download, a utility to 'talk' to the drive and change the ata speed from 100 to 66.

by opatzg9

You could always buy a pci ide card and run it at ata100 from there. $30 seems to be the going rate. Try Newegg.com. Good Luck

by cg it

well, the IDE controller on the mainboard actually sets the direct memory access. A lot of mainboard BIOS and chipsets [older boards] only handled UDMA 33 and UDMA 66. If you board handles UDMA / ATA -100 mbs transfer rates, then the BIOS autodetectshould get this information from your hard drive and set the transfer rate according to what the hard drive tells it. If you mainboard does not handle UDMA / ATA -100 mbs transfer rates, check to see if there is a BIOS update available. Failing all that, Go with the ATA-100 CPI controller card and disable the onboard IDE controllers.

This discussion is closed to new replies.