Discussion Locked

Atapi CD R/RW Driver updates

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Have older CDR/RW Atapi CRW6206A, firmware 1.2A, driver Microsoft 5-11-98. Won't work with 700MB (80 minute) CD's, only the 640MB version. Is there a driver update to solve this problem?

9 replies

by sgt_shultz

there might be. look for patch for drive and/or patch for your burner software on their respective websites...

by ann777

There's drivers for firmware 1.2a and 1.3a for this driver at:

http://www.benq.com.au/products/cdr/service/
drivers2.htm##cdrw

"16a.exe" ; but I do not know if it would do what you need it to do. What you probably should look for is whether or not you could flash the cd-rw controller BIOS with an update and how to do that if it will upgrade you from 640 to 700.

by thechas

3 factors need to support large capacity disks for you to be able to burn 700MB CDs at full capacity:

The CD-RW drive hardware;

The CD-RW drive firmware;

The actual CD burning software.

If any of the 3 do not support 700MB CDs, you will be limited to 650MB burns.

Roxio / Adaptec version 3 does not support 700MB disks.
Version 4 and later do.

Chas

by csmith

With Benq it is likely once yopu update the firmware it will not write 700s because of the design of the hardware.
Good Luck.

This discussion is closed to new replies.