Discussion Locked

ATX Power Supply

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How to diagnoise a ATX Power Supply without plug onto a Motherboard. What two pins to jumpt start?

3 replies

by republic_resource

What watt power supply? and what runs off it? It may be overloaded. Does the fan work?
Replacing it may be easiest, and is less than $40. Otherwise, use a multimeter to check the voltage level at each supply output against a pinout chart for your power supply.

by republic_resource

(note-2)regarding power connections for the 20-pin plug; ground is shown as connector numbers 3, 13, 5, 7, 15, 16, 17; and the PS ON is number 14
(good luck, wear rubber sole shoes (ha) )

This discussion is closed to new replies.