Discussion Locked

ATX Power Supply blew up on power up

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am using Windows 2000 pro, a PIII 733mhz, not overclocked, with a 300W ATX power supply, with a 3 com NIC card, a GeForce 4 MX video card, an Intel modem, 236 MB SDRAM. a Pioneor 16X DVD. I had a problem upgrading my video card to the GE Force from a SIS 8MB. After finally reinstalling Windows 2000 and all the updates, after turning pc off from the shut down feature, the computer would not auto shut down I had to turn the power off rom the power supply. When I turneed the pc back on the powersupply just started smoking and DVD door was ejected. I quicly unhooked the power supply and installed a new power supply, whne turning on pc the hard drive would not spin and would not boot, I expect that it could be from the video card. Anyone have any clues. I am really searchign for an answer on this one. I never saw a power supply blow like that.

HELP

ROb

1 reply

by thechas

My best guess assumes that you have an AGP video card.

If the video card was not fully seated in the AGP port, it is possible for 2 pins to short out on the card.
If so, it is possible that an on-board voltage regulator has blown also, loading down the 12 volt or 5 volt power.

To check for this problem with the video card, look closely at how far the card is seated in the socket.
Remove the bracket from the card, and seat it into the socket again.
If it goes in abit further, then, thatwas likely the root cause of your problem.

If so, then I would not trust the motherboard, and perhaps some of the plug in cards.

To check the drive itself, unplug the IDE cable from the drive, and listen for the drive to spin-up and run it's post test when you turn on the system.

Chas

This discussion is closed to new replies.