Discussion Locked

AutoCad R14 and Windows 2000.

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Sending a print job to an HPLJ 4V from autocad shifts the image to the right side of the page so the outline is not showing. Adjusting the plot from MM to INches helped with the size but not position. Windows 95 system prints this same image ok!
Anyone know of a solution?

3 replies

by sixfourtykilo

I'm not positive on this, but the last I heard R14 was NOT compatible with Win2k and that is why you're having printing problems. I think it was initially said that R14 did not work with Win2k because no printer drivers were made or supported, etc. If I'm wrong, I'm sorry, but I believe this is what I heard. I'm almost sure, though, that r15 and r16 are ok.

640k.

This discussion is closed to new replies.