9 replies
by thechas
The web site that I found for Azza was useless.
No information about older products, and NO downloads.
A BIOS update "MAY" be the answer IF the update specifically addresses a RAM limit.
If my memory is working right, this is a socket 7 motherboard?
If so, it is VERY possible that there are some bizarre RAM limitations.
I recall a number of strange RAM limits on early DIMM motherboards.
I had one that allowed up to 128MB in the first 2 DIMM slots, but would only use the 3rd DIMM slot if ALL DIMMs were 32MB or less.
What I believe you are hitting, is the address limit of the memory controller on the motherboard.
If so, there is NO update or work-around.
If you decide to look into a BIOS update, make sure that the BIOS is for the exact motherboard that you have.
Since Azza does not have any downloads, you may be stuck with a 3rd party BIOS seller.
Unicore software www.unicore.com sells customized BIOS for nearly all motherboards.
Expect to pay around $70 US for a new BIOS.
Chas
by thechas
Finally found some info on the MVP3 chip-set.
http://www.via.com.tw/en/apollo/MVP3.jsp
Looks like it supports up to 768MB of RAM.
So, any limits would be from the BIOS code, or the motherboard manufacture NOT using all of the address lines.
Chas
by thechas
Hi,
Got your message.
I would not spend money for a BIOS update.
If you can find a BIOS update that is for your specific motherboard, it would not hurt to flash the BIOS.
Just be sure to follow ALL precautions in the instructions.
I keep on hand a 128MB single density SDRAM DIMM. I use this as a test module to verify if a suspect motherboard has RAM limits, or just cannot address higher density RAM.
I suggest that you search for some older technology DIMMs and switch to those.
A pair of double sided (chips on both sides) 128MB DIMMs should do the job for you.
Your slowdown is likely caused by problems on the data bus related to the extra RAM that is not being seen.
Running with RAM that is not properly recognized by the BIOS is sort of like installing double wide drag slicks on an old Volkswagen Beetle.
Yes, the wheels still turn, but the extra weight and width of the large tires actually slows the system down.
Chas
by kamotto
Poster rated this answer.
by sgt_shultz
by kamotto
Thanks for your answer...I know I have the right "kind" - I triple checked and even tried different brands...
by kamotto
Chaz
Thanks for your informative and knowledgeable answer. I too, had gone to the Azza website and found it useless. They have yet to reply to my e-mail, and I am not expecting them to. Since my post I added a 64MB stick in the 3rd bank and now I get 256MB (it's still not detecting all memory, but I was considering just living with it, except that now the PC seems SLOWER!).
Based on what I just told you and what you said about the BIOS, do you think an upgrade is in order, if I can find one that addresses the RAM issue?
I am going to give you the 125 points for your answer, plus a bonus if you continue to help me sort this through. I really appreciate your time.
by kamotto
by kamotto
Thanks, Chas...
I am going to see if I can find the low density modules. I think that's the trick...
Again, thanks for all your help, and happy holidays.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending