3 replies
by albatros1 Accepted solution
by hal 9000 Accepted solution
On just about every M'Board the IDE Drive are the default drives to boot from and the SATA Drives if not actually needing drivers do write some files to the Default Drive to tell the computer where to find the Boot Drive or the boot files as well as any SATA drivers that where required to be installed.
What it sounds like you have done here is to install the OS onto the SATA HDD without the IDE drive being present or partitioned so it becomes blank to the system. When you partitioned the IDE Drive that became the Default Boot Drive and the system is looking at that for the directions on where to find the OS to boot from. As there are no files there you are getting the error massage and it doesn't matter how the Drive Names are setup within Windows at the BIOS Level the IDE drive will always be the C Drive.
The solution is to perform a In place Install of your OS with the IDE Drive in Place and select the SATA drive to install the OS to buy [b]Do Not!!!!![/b] disconnect the IDE Drive as the necessary files never will be written to the default drive to point the computer where to look for the Boot files to allow the system to load.
You can perform a In Place Install or Repair Install by following the directions here
Col
by anishks Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending