Discussion Locked

Black monitor with new RAM

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed one 128MB non-parity SDRAM DIMM stick on my K6-300/64MB (2-32MB EDO SIMM parity stick)
with W98 O.S. and the monitor remained black from
the boot-up onward. The motherboard manual states
it can support both EDO or SDRAM (64 & 128MB)
for which slots are provided. I know there may be a parity/non-parity/non-ecc issue, but is the real cause of the black monitor, because the memory needs to be paired with either a terminator or another equal memory stick?

7 replies

by saihib

Hello, you bought incompatible memory. From your post, the only thing that has changed is the memory.

by bhawks001

I didn't add that the 2-32MB sticks were removed when the 128 MB stick was in place, thereby giving a black monitor. Saying that the 128 MB stick is incompatible does tell me why it is; again, does the 128 MB stick need a duplicate or a terminator?

by hinrgman

did you remore the 2-32mb simm?? If not try removing them and the 128mb stick should work according to your manual. you cannot combine different types as you attempted. The one 128mb will still give you double what you startrd with..

by bhawks001

Yes, the 2-32MB sticks were removed when the 128MB stick was in place, and hence the black monitor. Does the 128MB
need to have a duplicate stick next to it, or a terminator?

by thechas

Most of these motherboards have limited compatability for using both types of ram (SIMM and DIMM) at once.

Also, the DIMM sockets usually have a jumper to select EDO vs SDRAM.
If the jumper was set to the edo position (5v), with the SDRAM (3.3v)you may have damaged the new SDRAM module.

Chas

This discussion is closed to new replies.