Discussion Locked

Blank Screen

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an IBM 1400 series Thinkpad and when I turn the computer on, the screen is just a whitetish looking blank. I can plug another monitor into the thinkpad printer port and it shows just fine

13 replies

by richard_barsby

Hi I can think of a couple of things to check 1 is the contrast and brightness settings on the note pad as these only effect the local screen, if that does not help you can check that the local screen is activated and not external only, if none of these work you can try to apply pressure/flexing around the screen edges to see if this brings it back also moving the screen lid from partially open to completely open and back again if this brings some life back then it is either poor connections around the panel or broken cable in the hinge area.

Best Regards

R.K.Barsby

by cddavis

I previously troubleshot everything you suggested, none of this solved the problem.

by psyadi

ok laptops switch between monitor and laptop screen using the "Fn" & "4" i think. There will be a picture of a monitor or blue square on the key you need to press with the Fn (function) key. This will allow the laptop to go back from monitor to laptop screen.
Regards
-Psy

by cddavis

On my computer it is "Fn" & "9", however that is not the problem. The problem is my thinkpad monitor screen is blank.

by psyadi

sounds like your connection from the laptop screen into the laptop may be damaged. if you are comfortable with it take it apart and see if there is any obvious damage.

by cddavis

No, I'm not comfortable with taking apart my computer and I'm trying to keep from paying anybody else a bunch of $$ to do it. However, I may not have any other recourse.

by cmrober

Concur with answer #1- probably a loose connection around the perimeter of the screen. Mine had the same problem. Hopefully you have a warranty???

by moethecrow

Hello CDDavis,
I will need to know some more info from you to help out. Let me start by telling you I am a certified IBM service technician. First I will need the model and serial number from your machine. The model should be 2621 or 2651 - something. The serial number should be next to it. Though I have not worked on a 1400 in particular most IBM laptops are similar and you should find this info on the bottm. With this info I can check your warranty status. Most likely the LCD panel is shot or the invertor board or the sub card. I also need the size of the LCD screen, there are several for this model. I can help you further after this info.

This discussion is closed to new replies.