Discussion Locked

Bois password lock out

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I bought a used IBM laptop. Can't get into the BIOS because it's blocked by a password. If I took out the battery that runs the CMOS will it clear the password? If not what can I do?

12 replies

by alpha-male

Removing the cmos battery will work. There should also be a switch or a jumper on the MB that will clear the BIOS password. You may want to check for an online manual about the jumpers etc.

Good luck!

by nannig3

Thats what I'm trying to find out if IBM uses a jumper or switch. Or if I just take out the battery.

by timwalsh

It may depend on the model of laptop. On many laptops (according to IBM Tech Support), the laptop must be taken to an IBM authorized reseller (with proof of purchase) to have a tech delete th password.

If you think about it, with the ease with which laptops can be stolen these days, this "small hassle" is a necessary evil to try to protect any data on the stolen laptop.

by jimharbert

You can use the DEBUG command to delete the BIOS password. At a DOS prompt, type DEBUG [enter]; type o 70 2f [enter]; o 71 ff [enter]; q [enter]; reboot the computer and enter the BIOS

by rcom

Removing the BIOS supervisor password by disconnecting the CMOS battery will cause the system to fail to boot and return one or more of the following Thinkpad Error Codes: 161, 163, 171, or 173.

What about the place where the laptop was bought from. They don't have the password?

Proof of purchase usually helps when seeking support from IBM. In the past when this same question comes up the people posting here usually bring up the fact that stolen laptops are a real pain in the drain and that info like this should not be given out in this type of forum.

by franjent79

Removing the battery will remove the password, but if you remove the battery you might have to config bios all over again. Just remember that. So kept your hardware disk. I sure there's no other way to get around that.

This discussion is closed to new replies.