Question Locked

Boot error after connecting second HDD that has been connected before

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I'm having problems booting my PC. I've recently reinstalled Windows XP and then tried to reconnect a relatively new (2 months) Seagate Barracuda 160gb drive via IDE, exactly as it was connected before when it worked perfectly. I then rebooted and had an error saying that I need to select a boot device or place media in the selected boot device. I rebooted with the XP disc in the CD drive and Windows went through the setup process but then hung at the point of copying files. I disconnected the second drive and rebooted with the XP disc in the cd drive and the same error appeared again, so I've again had to reinstall windows as it won't let me repair the previous installation.

Could this be an IDE cable problem, perhaps, or one of my hard drives dying on me?

Any thoughts and tips would be most appreciated.

thanks

Jamie...

5 replies

by ismail_ngr

Hi Jamie,

I tought may be your second HDD's jumper need to configure correctly. Like Master in old HDD and Slave for New 160 GB HDD. Otherwise your can't use single IDE cable in your PC with Dual HDD. Always try to firm connection the IDE cable end in HDD and M/B. Use ATA 80 IDE connector (such hard, thin wire and not flexcible) Insted of old type ATA 40 IDE cable.

Another possible is use secondary IDE port for the HDD. But You need to configure your CDROM as Slave. Otherwise you face same problem again.

Also go to your system BIOS and add 1st Boot Device in CDROM and, 2nd Boot Device is IDE-0. Next disable all boot device including try to search other boot devices. I don't have any doubt in your BIOS compatible for new 160 GB HDD. Reason is You said " exactly as it was connected before when it worked perfectly." So doubt only in jumpers and BIOS settings. Feedback to me after the attempt. Insha Allah we will try other ways later. take care.

--
Muhammad Ismail .H
Chief Executive,
Digital Net Services,
India - 611 002.
Direct : +91.98424.96391
"Truth Always Triumphs, "
http://en.wikipedia.org/wiki/User:Ismail_ngr

by jamie.hancock

Thanks Man,

I'll try to grab an IDE 80 cable on the way home from work and see if that helps. My second drive is set to Slave already, so the jumpers are not the issue.

i'll try everything else you've suggested and let you know the outcome.

Thanks again...

Jamie...

by danlm

I always wondered if you could do that, but never tried.

Have to remember that one.

Dan

by raymond.carroll

All you need to do to resolve this is edit the boot menu. Start by right clicking on My Computer on your desktop. Then choose the Advanced tab. Click on Start up and recovery settings to open another dialogue box. You should see an EDIT button. This will open the boot notepad editor. You will probably see something like this "multi(0)disk(0)rdisk(0)partition(1)\WINDOWS="Microsoft Windows XP Home Edition"" IF there are any duplicate entries, delete one of them and choose file/save. Restart the PC and you will be ok.
Hope this helps.

Ray C

This discussion is closed to new replies.