7 replies
by fred07
1st You could be close to a Power Supply failure.
2nd Make sure the Master HD is on the far end of the Cable and the slave is in the middle.
3rd If no jumpers or you wish cable select the master is on the far end and the slave is in the middle.
4th If you are using an ata100; The blue goes to the MB the Master to the far end [black] and the middle is slave [gray].
5th If all was well and you suddenly had this problem, I would look to the power supply first.
6th Check your jumpers against the WD website as older HD's somtimes required a two set jumper to be on the same line as a different mfg'd HD.
7th You may also do some cabling changes as; Put one HD one one cable and the other on the secondary ide with your cdrom.
Hope this helps??
by ismail_ngr
Hi,
probably u r HDD affected with Win95 CIH virus on Apr 26 day. Try to find the right soloution for removel procedure on Win 95 CIH. Some more info on the Win95 CIH virus on the below link
http://dgl.com/msg3/messages/258.html
Also try the below link for some data recovery software for at the moment. try to download the demo version and try b4 to buy.
Do feedback on my email address ismail_ngr@yahoo.com. bye 4 now.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending