Question Locked

boot problems

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an older Compaq Presario 1240 with a 4GB hard drive, 64M of Ram and an older Phoenix BIOS (the version number is not shown in the setup program). The original OS is Win98. When trying to reload the operating system, problems occured in booting from the Win98 floppy (with CD support). I repeatedly checked the boot order in setup, it shows floppy/CD/HDD even though when running the PC always booted to the hard drive first. I finally got setup to begin - it went as far as setting up the hardware and stalled. Upon restarting it goes to the same spot and stalls. I've tried to write zeros to the drive with PowerMax or use DBAN to start fresh - laptop won't boot from floppy! When running, clock was accurate - so I assume CMOS battery is OK. Now when booting I get "operating system not found" message and still cannot run ANYTHING from floppy - even though BIOS boot order is correct. Can I "force" the system to boot any floppy -or- somehow wipe it clean without disassembling the machine and then reload 98 or ME? Thanks!

2 replies

by mjd420nova

First thing on these older machines is to be sure and save any changes made before rebooting, and do a cold boot each time. You could also try booting to the CD instead of the floppy and even go so far as to disconnect the floppy to force it. Also check that the harddrive is mounted and the partition is active. If I remember right, those were Samsung drives and got pretty flaky near the end of their lives, usually around 4 to 5 years.

This discussion is closed to new replies.