Double check the motherboard jumpers, power cables - pay special attention to the power cable on the floppy drive. One pin off will put you straight to ground, and make sure that the motherboard is not grounded out to the case by a motherboard mountplaced in the wrong place - no hole for mounting on the motherboard. - I am guessing you are talking about the CPU fan. Since this is your first build, read and understand the installation instructions that came with the motherboard. Try to understand what the CMOS settings are and what they mean. Different motherbaord manufacturers have differnet names for the same thing in CMOS. Most are the listed the same across manuals, but not all. Ensure the power supply is disconnected when making any hardware changes/moves on the motherboard. Ensure that you are well grounded before touching any of the components. Start with the motherboard, CPU, ram, and video installed to begin with. Should all be successful, install one device at a time, starting with the floppy drive and adding hard drives, and other drives, one at a time, after each successful POST. PC 100, or PC Chips boards usualy have most expansion devices onboard, but install each above board expansion card one at a time, just as with the drives. This way, if the system will not POST, you can usually start trouble shooting with the last device installed. When all the hardware goes well, start loading the OS, install drivers and externals. Enjoy the satisfaction of building yourfirst system!
I hope this helps