Discussion Locked

Building PCs from scratch

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Being a support technician, I am frequently asked to upgrade customers' PCs. However, my most perplexing issue is with installing the motherboards, particularly older "Socket 5" & "Socket 7" boards.

While the manufacturers' documentation (booklets) are reasonably accurate and complete, some questions are just never answered. When installing a motherboard, how can you tell if the board must be:
a.) insulated from case grounding
b.) grounded through the printed circuits on the bottom of the board at the mount points
c.) grounded through the printed circuits on the top of the board at the mount points

This has always been a trial-and-error process for me that I have never been able to have satisfactorily answered. This applies to both the AT and ATX format of power supply/case/motherboard combinations.

If you could offer some guidelines, this would greatly reduce the risk of "fried" components and wasted time.

Thanks

4 replies

by dmiles

In building from scratch I will usually as a rule of thumb use insulators on the back side with the mounting spacers,this protects me from causing a shortout
On the top is best determined on how close to circuits and components are layout on the top,in most cases I use none.
There is no general rule per say,but to protect one self,use the insulators,it does not require any time.

by thechas

As an old electronics technician, I always have grounded everything that I can. I have never had a computer board damaged from excessive grounding.

If the area around the screw hole is either bare circuit board, or a tin plated circle around thehole, just use standard screws.

The only time to use the insulating washers is if there is a circuit trace near the screw hole. (I am not refering to the tin plated ground plane around some of the mounting holes) It is possible for the screw tocut through the insulation on the board and short to the trace.

If in doubt, use a plastic standoff on mounting holes that are not tin plated.

From time to time, techs get concerned about ground loops, and say that one ground screw is better than several. While there is truth to the concern, the ground path through the mother board tray is large enough to negate the effects of ground loops.

This discussion is closed to new replies.